[Kenwood] 430
Guillermo
[email protected]
Tue, 20 Aug 2002 18:32:50 -0300
Hello Jim, may be dirty contacts in memory channel switch. Regarding
the other bands, there's a note from Kenwood to clean T/R relay from
intermittent contacts.
Check Kenwood's site.
Good luck
Guillermo - LU8EYW.
[email protected] escribi�:
>
> I have a ts-430 that was repaired about 1 years ago,
> because of the relays going bad on the filter board.
> Well, now it has failed again...completely..receiving
> only on 3.5, 7 and 10 mhz. Also, when in the memory
> mode, mostly in the channel 4 position a relay keeps
> dropping out, it makes quite a lot of noise. I have
> cleaned the relays on the filter board(4 had been
> replaced) and you can hear them switch on, but still no
> receiver improvement. Any ideas?
>
> 73, Jim W4KWD
> - - -
>
> Your moderator for this list is:
> Larry Wilson KE1HZ [email protected]
>
> _______________________________________________
> Kenwood mailing list
> [email protected]
> http://mailman.qth.net/mailman/listinfo/kenwood