[Kenwood] 940 Transformer
WBØGZR Biker DaddyDawg
daddydawg at peoplepc.com
Thu Jun 19 02:00:43 EDT 2008
Will not sure, the timer button is not in however I just replaced the on/off
button & before I had to push the timer button in at times to power up the
radio with the old switch but after I put the new one in, I had to push the
timer button just once & it had been working ok for about a week. Just
before it turned itself off the lights dropped in volts but came back up. I
never use the timer but can it mess with the radio even with the button push
out? How can I jump or disable the timer to make sure that's it or not. Boy
would that be great if that's all it is. Rick WBØGZR
----- Original Message -----
From: "Steve Harrison" <k0xp at dandy.net>
To: "WBØGZR Biker DaddyDawg" <daddydawg at peoplepc.com>;
<kenwood at mailman.qth.net>
Sent: Wednesday, June 18, 2008 10:42 PM
Subject: Re: [Kenwood] 940 Transformer
At 10:24 PM 6/18/2008 -0500, WBØGZR Biker DaddyDawg wrote:
>I think my 940 for my RV's transformer bit it. All the front taps are
about 120 volts with power button off & when I push the power button on,
the volts drop down or go to zero. I was in a QSO & let off the mic then
the radio went off & would not turn back on. Check the voltages on my shack
940 which is not the same. Anyone have one for sale or do you know where
the magic button is located? Thanks Rick WBØGZR
Did you happen to engage the timer?
Steve, K0XP
--
No virus found in this incoming message.
Checked by AVG.
Version: 7.5.524 / Virus Database: 270.4.0/1508 - Release Date: 6/18/2008
9:08 PM
More information about the Kenwood
mailing list