From af5cc2 at gmail.com Fri Oct 16 10:45:54 2015 From: af5cc2 at gmail.com (John Geiger) Date: Fri, 16 Oct 2015 09:45:54 -0500 Subject: [Kenwood] FS: Kenwood DFK-4C remote kit for TM-V7A/TM-G707 Message-ID: I have for sale a Kenwood DFK-4C remote mounting kit for the Kenwood TM-V7A and the TM-G707 FM transceivers. Might work with additional models as well. It consists of the faceplate brackets, the 13 foot long faceplate cable, and the mobile mounting bracket for the radio body. It does NOT include the microphone extension cable. I am asking $25 shipped for this in the US and can take paypal/check/MO. 73 John AF5CC From kenw8ek at gmail.com Thu Oct 22 19:36:00 2015 From: kenw8ek at gmail.com (Ken, W8EK) Date: Thu, 22 Oct 2015 19:36:00 -0400 Subject: [Kenwood] Kenwood HF Amp, Speaker, Wattmeter, Crystal Filter, and more FS Message-ID: <562972E0.8060204@gmail.com> Kenwood HF Linear Amplifier, Filtered Speaker, HF Wattmeter, Crystal Filter, and other miscellaneous items For Sale: Kenwood TL-922 A, HF Linear Amplifier: The Kenwood TL-922A HF linear amp is designed to provide close to maximum legal power, utilizing two 3-500Z high performance transmitting tubes. The amp features two meters for maximum operating convenience. Power is 2000W PEP SSB, 1000W DC CW/ RTTY input. Drive power is 80 or more watts. For all practical purposes, the TL-922 A is similar to the SB-220/ 221, but with improvements added, since it was designed after the Heath amps. It also includes 160 meters. It has larger transformers, and heavier duty tank circuit. This one has had the filter capacitors replaced, the Harbach "Soft Key" added, along with a glitch resistor, and various protective diodes. All bulbs have been replaced. The Eimac 3-500's produce from 1300 watts to over 1500 watts into a dummy load, depending on band. Power output was measured with an LP-100 A wattmeter, calibrated traceable to NBS. Electrically, this amp is a 10, and cosmetically it is a 9.9. It is an exceptionally nice amp, both electrically and cosmetically. Power requirement is 120V AC at 28A or 240V AC at 14A. Paper work is included for $1250. Pickup near Ocala, FL, is definitely best. Linear Amp Switching Cable for Kenwood Rigs: This cable goes from a Kenwood transceiver to a linear amplifier to switch the amp from transmit to receive. One end has a DIN connector, as is used with most Kenwood rigs. The other end has an RCA phono plug, as used by most linear amplifiers. Before using this cable, please check the switching capabilities of your transceiver, and the requirements of your amplifier. This cable is for switching the relay. $15 Cable as above, but also includes the connection for ALC in addition to the amplifier relay keying. $20 Kenwood SP-31 Speaker with Filters: The Kenwood SP-31 speaker is much more than just a speaker. It has provision to switch between two separate radios. It also includes three degrees of filtering built into the speaker. With no filtering, the freq response is about 200 Hz to 3400 Hz. Using the low switch, the low end is changed to 400 Hz. High 1 drops the high end to 3000 Hz, while high 2 drops it to 1200 Hz. The interesting part is using combinations. High 1 and 2 together drop the high end to 900 Hz. Used with the low switch, one ends up with a 400 to 900 Hz bandwidth, which would be great for CW. All this in a speaker, without adding any filters to your rig! The SP-31 appears to be the same as the SP-230, except for the location of the "A-B" switch. This one works 100%, and looks fine. It includes cords for two rigs, and paperwork for $90. Kenwood SW-2100 Wattmeter / SWR Bridge: The Kenwood SW-2100 is both an accurate HF wattmeter and also an SWR meter. It will handle up to 2000 Watts of power, but only requires about 30 watts (depending on band) to get an accurate reading. It has 2000 W and 200 W scales. It features two meters -- one reads power and one reads SWR. The meters are fairly large 3 inch meters. This meter works 100%. Paper work is included for $75. DC Power Cable This is the heavy duty power cable as used on most of the Kenwood HF rigs, plus also many Icom, Alinco, and others. It has the 6 pin molex connector, with four pins used - two for plus and two for ground. The cable may not have ever been used. It looks good, and of course works fine. $22 Kenwood YK-88 S 1 Crystal Filter: This filter is 2400 Hz wide, and is the type that plugs in (as opposed to the solder in type), and is used on rigs such as the TS-450, TS-850, TS-940, TS-950, and others. This one works fine, and looks like new. Paperwork and hardware included for $85. Kenwood "Soft Cases" SC-35 soft case For Kenwood TH-78 dual band HT. Looks like new. Only $12. SC-8 T soft case For Kenwood TH-21, TH-31, TH-41 series HTs. Like new condition. $10 Accessories for the Kenwood TH-21 / 31 / 41 series HTs: Kenwood SC-8 T "Soft Case" for any of the TH-21 series HTs Appears to be unused, $12 Antenna adapter that fits the TH-21 series HTs, and has an SO-239 on the other end, to accept a PL-259. $5 Antenna adapter that fits the TH-21 series HTs, and has a BNC on the other end. $8 Original Operating manual for TH-21 HT for 2 meters $8 Original Box, with inserts, for Kenwood TH-41, 440 MHz HT. $8 Kenwood W09-0315 charger This charger is used to charge the larger PB-21 H batteries for the TH-21 series, and also on other Kenwood radios. It has a standard 2.1 mm coaxial connector. $12 Rubber Duck Antenna: BNC - Original from Kenwood TH-215, about 5 inches long - $10 Original Box for Kenwood TM-221 two meter mobile transceiver. $6 Original Box for Kenwood TH-41, 440 MHz HT. $8 Original box for Kenwood TR-2600, Two meter HT. $8 Original Manuals for Kenwood equipment: All manuals are in very nice condition, for Kenwood equipment. All are Operating manuals unless otherwise specified. All are original manuals only. SPECIAL: Buy two, three, or four of my books/manuals, and take 10% off. Buy five or more and take 20% off. TH-21 HT for 2 m, $8 TH-215/315/415 HT for 2 m, 220 MHz, or 440 MHz, $10 TH-225, 2 m HT, $12 TH-235, 2 m HT, $15 TH-241/441/541 mobile FM transceivers ...For 2 m, 440 MHz, & 1200 MHz, $12 TM-221/421 2 m or 440 MHz mobile, $12 TM-261/461 2m or 440 MHz mobile, $12 TM-2570/2550/2530 2 m mobile, $15 TR-2400, 2 m HT, $12 Service manual for TR-2600, 2 m HT, $12 TR-9000, 2 m multimode, $12 TS-120 S/V, HF xcvr, $20 TW-4000 dual band mobile, $15 Service manual for TW-4000 dual bander $20 TW-4100 dual band mobile, $15 BC-5 DC to DC quick charger $2 LF-30A Low Pass Filter $5 MC-30 & MC-35 hand microphones $4 MS-1 mobile stand $3 PB-1, PB-2, PB-3, & PB-4 battery packs $3 PB-24 battery pack for TR-2400 $2 PB-25 H battery pack for TR-2500 $2 PS-6 power supply $5 PS-30 power supply $4 SMC-24 speaker mic $3 SMC-25 speaker mic $3 SP-430 speaker $2 SP-820 Speaker $2 These are original Kenwood manuals only. I also have many other accessories available such as many different types of microphones, HTs, HF, VHF and UHF rigs, HF and VHF/UHF antennas, etc. Just too many to list here. Please e-mail your requests. Prices do not include shipping from Florida. Thanks. 73, Ken, W8EK Ken Simpson E-mail to W8EK at FLHam.net or W8EK at arrl.net Voice Phone (352) 732-8400 From david.kirkby at onetel.net Fri Oct 23 09:24:10 2015 From: david.kirkby at onetel.net (Alfonso Flores) Date: Fri, 23 Oct 2015 06:24:10 -0700 Subject: [Kenwood] important message Message-ID: <00006c371a06$58d319f7$0fc438b8$@onetel.net> Hello! New message, please read Alfonso Flores From david.kirkby at onetel.net Fri Oct 23 09:24:15 2015 From: david.kirkby at onetel.net (Alfonso Flores) Date: Fri, 23 Oct 2015 06:24:15 -0700 Subject: [Kenwood] important message Message-ID: <00005b7518e6$e8655406$a6b582bb$@onetel.net> Hello! New message, please read Alfonso Flores